![connect suzuki df140 to nmea 2000 network connect suzuki df140 to nmea 2000 network](https://img.nauticexpo.com/pdf/repository_ne/21237/df40a-50a-60a-122146_1mg.jpg)
Caution: We strongly recommend that you shut off the power supply to the power cable when the unit is not in use, especially in saltwater en- vironments.
#Connect suzuki df140 to nmea 2000 network install
If this results in electrical interference, connect direct to a battery but install an in-line switch on the cable. Attach the display power cable (with provided 3-amp fuse) to an accessory switch or power bus. Powering Your Display Unit The display unit works from a 12-volt DC battery system. It is labeled "NMEA 2000 POWER." The branch with four wires (blue, yellow, orange, and shield) is a data cable, labeled "RS-232 COMM." It supp The thinner branch with three wires (red, black and shield) is the power cable for a NMEA 2000 network. The thicker three-wire cable (white, red and black) is the power supply for your display unit. Power Connections Your unit comes with a power/data cable that splits into three branches, each with several exposed wires. The segment covering changes in installation procedur Your unit now packs with a 2-foot (61 cm) blue-to-red adapter cable, 15- foot (4.6 m) extension cable, LGC-3000 GPS module, double T connector and two 120-ohm terminators. 988-0151-182 Addendum I LMS-480M, LMS-480DF & ® GlobalMap 4800M This addendum addresses new items packed with your unit, changes to ® installation procedures, and NMEA 2000 upgrades not documented in the LMS 480M, LMS-480cDF and GlobalMap 4800M manuals.